Motorola T3 Podręcznik Użytkownika Pobierz pdf (Strona 18)

Motorola, Inc Page 18 of 24

Install the Switch in a standard EIA-19 equipment rack using the provided mounting ears. Install

other network equipment such as routers and Ethernet switches.

Premises termination with the XLP-7038 is normally done by directly punching the wire pairs to a

termination block. No cross connect is required since the XLP system is not compatible with

telephone wiring in the same wire pair.

1) Install a jumper wire between the RJ11 jack and the premises wiring

a) One wire pair, connected to the RJ11 pins 2-3

2) Install a jumper wire between the end-point termination and RJ11 jack

a) Likely, the end-point termination will be an RJ11 jack, thus a standard RJ11 cable is used

to connect the XLP-701

For a detailed list of commands, refer to the XLP-7000 Command Reference guide or XLP-7000

User Guide. Details are available for configuring IP address, ACL, SNMP, VLANs, QoS, SNTP,

IGMP, etc.

Default IP address: 192.168.1.3

Default user name: admin

Default password: <blank>

4) Login using telnet or the serial console

5) Issue these commands

a) interface dsl config port(1-8) max-down 70 max-up 20

b) interface dsl power enable port(1-8)

c) interface remote enable port(1-8)-1

d) interface remote power enable port(1-8)-1

6) Use these commands to monitor the system

a) show interface dsl status

b) show interface dsl statistics

c) show syslog messages level trace

Review the diagnostics and monitoring section at the end of the document for explanation of the

line monitoring parameters.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

Motorola T3 Podręcznik Użytkownika Strona 18