Motorola RG2200 Podręcznik Użytkownika Pobierz pdf (Strona 39)

SETTING THE REMOTE CONTROL ID

Your NSP uses the following table when programming your remote control ID to work with each TV in your household. You

may use it, too.

To program the remote control ID:

Remote Control ID Operates TV Mode

0 Local TV1--TV in same room as RG. Remote is set to operate in IR mode. IR

1 Remote TV1--TV in a different room than the RG. UHF

2 TV2 (remote TV). UHF

3 TV3 (3-stream models only). UHF

SRC-300 SRC-200

1. Press the LED key and hold it down until the LED

flashes rapidly.

2. Press the REC key. The LED stops blinking at this point

and stays on solid.

3. Press the A key. The remote is now in programming

mode.

4. Enter the single-digit remote control ID from the table

on page 39.

1. Press and continue to hold the A button until the LED at

the top of the remote flashes rapidly.

2. Enter the following three-digit sequence: 7-8-9. The

remote is now in programming mode.

3. Enter the single-digit remote control ID from the table

on page 39.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 87 88

Brak uwag

Motorola RG2200 Podręcznik Użytkownika Strona 39